Pentax WG-10 Guia De Utilização
148
3
Taking Pic
tures
•
Confirm that the battery is sufficiently charged before starting interval
movie recording. If the battery is not sufficiently charged, it may
become depleted during interval movie recording and cause recording
of the movie to stop.
•
When performing interval movie shooting, the settings are fixed as
follows; Recorded Pixels: V (1280×720), Quality Level: C, Movie
SR: P (Off), and Flash Mode: a. However, shooting is done at a frame
rate according to the recorded pixels (p.143) set on the Movie menu.
•
Interval Shoot stops if the SD Memory Card is removed or inserted
during standby.
•
Sound cannot be recorded in Interval Movie mode.
•
When you use the SD Memory Card, use SD Speed Class 4 or higher
cards.
•
If you set a start delay, a start time corresponding to the current time
and the start delay you set is displayed in real time.
•
The total time you can set differs according to the shooting interval
you set, as indicated in the table below.
Interval
Total time that can be set
30 fps
15 fps
1 min
10 minutes to 5 hours
and 59 minutes
(in increments of 1 minute)
10 minutes to 5 hours
and 59 minutes
(in increments of 1 minute)
5 min
30 minutes to 29 hours
and 55 minutes
(in increments of 5 minutes)
15 minutes to 29 hours
and 55 minutes
(in increments of 5 minutes)
10 min
1 hour to 59 hours
and 50 minutes
(in increments of 10 minutes)
30 minutes to 59 hours
and 50 minutes
(in increments of 10 minutes)
30 min
3 hours to 179 hours
and 30 minutes
(in increments of 30 minutes)
1 hour and 30 minutes
to 179 hours and 30 minutes
(in increments of 30 minutes)
1 hr
6 hours to 359 hours
(in increments of 1 hour)
3 hours to 359 hours
(in increments of 1 hour)
WG10_OPM_ENG.book Page 148 Friday, February 1, 2013 5:30 PM