Pentax K20D Guia De Utilização

147

5

 

1 Remove the external flash unit for which the channel was set on the 

camera, and place at the desired location.

2 Set the flash mode of the camera to r , and pop up the built-in flash.
3 Confirm that both flashes are fully charged and then take the picture.

 

1 Set the wireless mode of the external flash directly connected to the 

camera to [MASTER] or [CONTROL].

2 On the wireless flash unit, set the wireless flash mode to [SLAVE] and 

set the channel to the same channel as the camera. Then, place at the 
desired location.

3 Confirm that both flashes are fully charged and then take the picture.

HSb (High-speed sync) is not available when the camera is set to discharge 
the built-in flash.

MASTER

Discharges both the flash directly connected to the camera and 
the wireless flash unit.

CONTROL

The flash directly connected to the camera is discharged as a 
test flash only and does not discharge as main flash.

Shake Reduction is not available in Wireless mode.

e_kb442.book  Page 147  Monday, February 11, 2008  3:22 PM