Panasonic TH-47LFT30W Guia De Utilização

1/2

Signal

Input label

Wobbling

Setup

On

Power management

Standby save

On

ECO

Off

OSD Language

English(UK)

Off

Screensaver

Enable

No activity power off

Enable

No signal power off

Press to select the menu to adjust.

Press to select “On (Enable)” or “Off (Disable)”.

On (Enable) 

 Off (Disable)

Press to exit from Setup.

• Power management: 

When this function is set to On, it operates under the following conditions to turn the 
power on or off automatically.

 

When no pictures are detected for 30 or so seconds during input from PC IN or 
DVI-D IN terminal:

 

  →  Power is turned off (standby); the power indicator lights up orange.

 

When pictures are subsequently detected:

 

  →  Power is turned on; the power indicator lights up green.

 

 

• This function operates only during input from PC IN or DVI-D IN terminal.

 • 

 

This function is effective when “Sync” is set to “Auto” and during normal viewing (one 
picture screen).

• No signal power off: 

Equipment power supply is turned Off when there is no signal.

 

When this is set to “Enable”, the power supply of the unit goes Off 10 minutes after 
the input signals stop. 

 

 

This function is effective during normal viewing (one picture screen).

• No activity power off: 

 When this function is set to “Enable”, the power is turned off (standby) automatically 

when there is no operation of the Display for 4 hours.

 

Starting from 3 minutes before the turn off, the remaining time will be displayed. 

No activity power off  3min

Press any key to abort.

 

 When the power is turned off due to this function, a message “Last turn off due to 
’No activity power off’.” is displayed next time the power is turned on.

 

 

During the screensaver is running, this function is disabled.

• Standby save: 

            When this function is set to “On”, serial communication is disabled during standby 

mode, reducing the power consumption during standby. 

 

            To perform serial communication while in standby, set this function to “Off(SERIAL)”. 

However, the standby power consumption is greater than when it is set to “On”. 

 

            Note:

 

      The factory setting is “On”.

• ECO: 

            This function adjusts the brightness of the backlight to reduce power consumption.

Off: This function does not operate.
On: Backlight brightness is reduced.

 

            Note:

 

            When this function is set to “On”, the “Backlight” setting in the Picture menu is 

disabled.