Panasonic MCUG522 Guia De Utilização

If the dust bag and filter areas are free
of clogs, check the extension hose.

Disconnect the hose from the wand
by twisting hose handle to unlock
raised tab from “J” slot.

Disconnect wand from nozzle hose.

Check for clogs in wand and nozzle
hose connection (indicated by arrow)
and clear any obstructions.

If the vacuum cleaner does not seem to have adequate suction, first check if the dust bag is full or if a filter is clogged.
Refer to DUST BAG REPLACEMENT (Page 11), SECONDARY FILTER CLEANING / REPLACEMENT (Page 12), and
 HEPA MEDIA EXHAUST FILTER REPLACEMENT (Page 12).

If the dust bag, filter areas and the
hose areas are free of clogs,
disconnect the nozzle hose from the
wand holder and check the nozzle for
clogging.

Lay unit on floor with nozzle flat as
shown.

Remove nozzle hose from body by
(1) pressing in locking tab and (2)
sliding up and (3) out of retaining slot.

Check and clear any obstructions.

Reinstall hose and connect hose to
wand.  Refer to ATTACHING HOSE
(page 6).

Reinstall wand to nozzle hose.

Return the vacuum cleaner to the
upright position. 

Plug in vacuum cleaner and turn on.

Plug in the vacuum cleaner and turn it
on.

Stretch the extension hose to
maximum length and then allow the
hose to return to its natural length.

This may pull the clog into the dust
bag.

If clog still exists, turn off and unplug
vacuum cleaner.

Remove hose from back of the
vacuum cleaner by pressing tabs and
pulling off.

Check and clear any obstructions
from the hose and suction inlet area.