Panasonic NVVP60SERIES Guia De Utilização

RQTV0114

You can record the contents of a disc onto a video cassette.
≥Select the unit viewing channel (or the AV input) on the TV.
≥Insert a video cassette with an intact erasure prevention tab.
≥Press [DVD SELECT] (

l 8).

≥Select the desired recording mode (

l 16).

Only discs that are not copy protected can be used.
≥Press [DVD SELECT] (

l 8).

≥Set “On-Screen Messages” to “Off” (Setup menu 

l 37).

≥Insert the disc to be recorded (

l 23). When you copy NTSC discs, 

select “NTSC” in “NTSC Disc Output” (Setup menu 

l 37).

 Select “dc” channel.
≥Recording is allowed only when the 

VHS input channel is set to “dc” (

l below).

1PLAY].

 Start playing the disc and find the playing start point.

;/DPAUSE].

1PLAY].

Start playing the video cassette and find the recording start 
point.

;/DPAUSE] and then press [¥REC].

 Put the unit in the recording standby mode.

 [;/DPAUSE].

 VHS recording and disc play start at the same time.

¬ To stop recording
1) Press 

∫STOP]. Recording will stop.

∫STOP].

Notes:
≥You can select the audio channel to be recorded on the Normal 

audio track when copying a bilingual DVD (

l 21).

≥Recording cannot be done if using a copy protected disc. By 

pressing [

¥REC] at “dc” channel during DVD playback, the 

message “COPYING OF THIS MATERIAL IS NOT ALLOWED.” 
appears on the TV screen.

You can copy programmes on a DVD-RAM disc to a video cassette 
with One-touch operation.
≥This function allows DVD-RAM discs recorded by Panasonic DVD 

recorders to be copied.

≥Insert the disc containing the programme to be copied (

l 23).

≥This function allows you to record the whole content on a disc 

automatically. Confirm that the remaining tape time is sufficient for 
recording.

When the disc is played all of the content or the tape reaches its end, 
this unit automatically stops copying.
≥The message is displayed on TV screen for a few seconds when 

DVD-RAM copying is completed.

¬ To stop recording
Press [

∫STOP].

¬ When “

Check the settings again.

Notes:
≥In this function, the index signal is automatically added on the tape 

for each of the programmes. You can find the desired programme 
with these index signals (

l 19).

≥This function does not work during timer recording standby mode.
≥When the copying starts, “On-Screen Messages” in the Setup 

menu is automatically set to “Off”. The “dc” channel is automatically 
selected (

l below).

≥If you press [DVD-RAM COPYING] again, the copying starts at the 

stop position memorized (Resume function 

l 23). “

” in the 

unit’s display flashes. 

“dc” channel
≥When the disc is played with the “dc” channel set, the TV 

screen displays the disc video.

VP60GL.book  Page 38  Monday, March 6, 2006  2:49 PM