Panasonic ICX Manual
164
ICX (International) issued June 2000
ICX-45-700
Chapter 5. Key Telephone Features
Section 700 - Operation
To erase a code stored on an FF key:
Note:
You cannot use the following procedure to clear FF keys that have been assigned as trunks.
Trunk keys can only be cleared through system programming.
To check a programmed FF key (Display Phone Only):
Hardware Requirements
•
N/A
Considerations
•
If a new code is programmed into a key, the previously programmed code is erased.
•
FF keys assigned as trunks must be cleared using system programming before new FF
assignments can be made.
assignments can be made.
•
The System can be programmed so that MCO 1 Trunk Access calls automatically use Automatic
Route Selection (ARS).
Route Selection (ARS).
•
The ANSWER key functions as listed in the table below.
Action
Result
1. Lift the handset or press the ON/OFF key.
Intercom dial tone
2. Press the PROG key.
3. Press the FF key that was programmed.
Programmed code displays
4. Press the HOLD key.
Cleared Function displays
Action
Result
1. Lift the handset or press the ON/OFF key.
Intercom dial tone
2. Press the CONF key.
C displays
3. Press the FF key to be checked.
Programmed data displays
4. Replace the handset or press the ON/OFF key.
Status
Condition
Operation when ANSWER key is pressed
Idle
No incoming ring
Ignore.
Incoming ring
Monitor ON (speaker) - Auto Answer for incoming ring.
Off-Hook
Off-hook signaling
Answer for off-hook signaling. Current conversation will be
put on hold automatically.
put on hold automatically.
No off-hook signaling
Ignore.
Note: When the extension has 1 non-appearing trunk on hold and 1 non-appearing trunk at talk, ANSWER key
operation is ignored and you can’t put the 2nd non-appearing trunk on hold.
operation is ignored and you can’t put the 2nd non-appearing trunk on hold.