Panasonic ICX Manual
26
ICX (International) issued June 2000
ICX-4.5-200
Chapter 2 - System Hardware
Section 200 - General Description
External safety devices (available from standard telecommunications suppliers) are required when
installing this unit outside the building.
installing this unit outside the building.
Primary Rate Interface Card (S-point)-PRI (VB-44540)
Same card as T-point.
One-Line SLT Card (VB-43702UK/HK)
Analog Single Line device can be connected to DEC card through this interface card.
OPTIONS
MFR Card (VB-44110)
The Multi-Frequency Receiver (MFR) card accepts dialled DTMF tones and determines the dialled
digits. Each card contains 8 receiver circuits.
digits. Each card contains 8 receiver circuits.
This card can be installed in either an option slot or any flexible slot. A maximum of one card can be
installed in a cabinet, with up to 6 cards in a fully configured system.
installed in a cabinet, with up to 6 cards in a fully configured system.
8-Party Conference Card (VB-44120)
This card provides a set of 8-party conference circuit. (These are in addition to the 3-party conference
circuits built into the CPC-96, TSW-288 and TSW-576.)
circuits built into the CPC-96, TSW-288 and TSW-576.)
This card is installed in a flexible slot. A maximum of one card can be installed in a cabinet, with up to
6 cards in a fully configured system.
6 cards in a fully configured system.
Built-In ACD Card (VB-44140)
This card, combined with the Voice Processor Unit card (4 circuits) (VB-44160), provides simplified
Automatic Call Distribution functions. MIS (Management Information System) reports can be output
from the RS232C port of the ACD card. The reports can be printed out by connecting a printer to the
RS232C port. However, a PC and printer cannot be simultaneously connected to the RS232C (the
RS232C cable must be used exclusively for one connection).
Automatic Call Distribution functions. MIS (Management Information System) reports can be output
from the RS232C port of the ACD card. The reports can be printed out by connecting a printer to the
RS232C port. However, a PC and printer cannot be simultaneously connected to the RS232C (the
RS232C cable must be used exclusively for one connection).
Only one Built-In ACD can be installed in a cabinet. A maximum of two Built-In ACDs can be installed
in a system.
in a system.
Built-In Voice Mail and Built-In ACD cannot be installed in the same cabinet, since they use the same
flexible slots.
flexible slots.
Built-In Voice Mail Voice Storage Card (VB-44170)
This is one of two cards required for Built-In Voice Mail. One or two Voice Processing Cards (VB-
44160 for 4 circuits; or VB-44150 for 8 circuits) are also required for Built-In Voice Mail.
44160 for 4 circuits; or VB-44150 for 8 circuits) are also required for Built-In Voice Mail.
The Voice Mail Voice Storage Card provides most of the functions of Built-In Voice Mail, including
hard disk storage of the voice data.
hard disk storage of the voice data.
Only one Built-In Voice Mail can be installed in a single cabinet. A maximum of four Built-In Voice
Mails can be installed in a fully configured system.
Mails can be installed in a fully configured system.
Don’t install the Voice Mail Unit from the top cabinet, otherwise the unit will be damaged by heat.
Built-In Voice Mail and Built-In ACD cannot be installed in the same cabinet, since they use the same
flexible slots.
flexible slots.