Panasonic NVVP60SERIES Guia De Utilização

RQTV0115

41

≥Some distortion is normal during search.

≥Check the settings in the On-Screen Menu “Picture Menu”.

≥Change the zoom ratio to “k1.00”.
≥Set the subtitle position to 0.
≥Go to “Video” in the Setup menu, and change “TV Aspect” to suit your TV.

≥Move the other equipment away from the TV as it may be picking up interference.

≥The connections were done incorrectly. Check the connections to the other equipment.
≥The external input channel “A1” or “A2”, to which the player is connected is not selected.

Press [INPUT SEL] to select “A1” or “A2”.

≥Copy-protected material was copied.

Copy-protected materials cannot be recorded normally.
Most commercially available videotapes and DVD discs (including rental soft tapes/DVDs) 
are copy-protected so that illegal copying is impossible.

≥Some discs may reproduce different audio levels.

If the audio in particular parts, such as speech, is set to a low or high level, it may be 
recorded on the video cassette at a low or high level.

≥[¥REC] or [

TIMER] has been pressed without a video cassette inserted. Insert a video 

cassette with an intact erasure prevention tab.

≥TUNER PRESET has been selected during playback. Stop the tape.

≥[¥REC] or [

TIMER] has been pressed without a video cassette with an intact erasure 

prevention tab. Use a video cassette with an intact erasure prevention tab.

≥[

TIMER] had been pressed with no timer programmes.

Set timer recording.

≥[Í/I] had been pressed when VHS is in the timer standby mode. Cancel Timer 

Programme before switching the unit to standby mode.

≥You are trying to display incompatible pictures.

≥[DivX] You are trying to play the DivX VOD content that was purchased with a different 

registration code. You cannot play the content on this unit.

≥[DivX] The DivX VOD content has zero remaining plays. You cannot play it.

∑∑, F∑∑

(

∑∑ stands for a number.)

≥An error has occurred. The number following “H” or “F” depends on the status of the unit.

Reset procedure:
Press [

Í/I] to switch the unit to the standby mode and then back to ON. 

Alternatively, press [

Í/I] to switch the unit to the standby mode, disconnect the AC mains 

lead, and then reconnect it.

≥If the service numbers fail to clear, note them and contact a qualified service person.

≥You haven’t inserted a disc; insert one.
≥You haven’t inserted the disc correctly; insert it correctly.

≥You inserted a disc the unit cannot play.
≥Disc is dirty. Wipe it clean.
≥You inserted a DVD-R which is not finalized.
≥You inserted a blank DVD-RAM.
≥A disc whose playback is restricted in the Setup menu is inserted.

Change the “Ratings” setting.

VP60GCS.book  Page 41  Monday, March 6, 2006  3:23 PM