Panasonic tx-l42u3e Guia De Utilização
T
uning and Editing Channels (D
VB)
38
Set DVB channel manually [Manual Tuning]
Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
t
All channels found will be added to the Channel List.
DVB-C :
1
Enter the frequency
2
Search
Auto
Auto
4
74,00 MHz
100%
100%
100%
Stopped
No.
Channel Name
Type
New
Free TV: 0
Pay TV: 0
Radio: 0
DVB-C Manual Tuning
Frequency
Symbol Rate
Service ID
Symbol Rate
Service ID
Signal Quality
Signal Strength
Signal Strength
jkl
ghi
mno
tuv
pqrs
wxyz
abc
def
t
Normally set [Symbol Rate] and [Service
ID] to [Auto].
ID] to [Auto].
DVB-T :
1
Adjust frequency for each channel
2
Search
[CH21]
100%
100%
100%
Stopped
No.
Channel Name
Type
New
Free TV: 0
Pay TV: 0
Radio: 0
DVB-T Manual Tuning
Frequency
Signal Quality
Signal Strength
Signal Strength
474,00 MHz
Data: 0
adjust frequency
select channel
t
Set where the level of [Signal Quality]
becomes the maximum.
becomes the maximum.
Update DVB channel automatically [Update Channel List]
You can add new channels, delete removed channels, update channel name and position automatically to Channel List.
69
CH 5
Searching
CH
Channel Name
Type
Quality
DVB-T Update Channel List
Progress
Free TV: 0
Pay TV: 0
Radio: 0
This will take about 3 minutes.
t
Channel List is updated while keeping your settings in [Favourites Edit],
[Channel List], [Child Lock], etc.
[Channel List], [Child Lock], etc.
t
Depending on the signal condition, the update may not work properly.
Display a notification message [New Channel Message]
Selects whether to give a notification message when a new DVB channel is found. [Off] / [On]
New channels found!
Press OK to update channel list.
Press EXIT to ignore.
t
Selecting OK will perform [Update Channel List].
Check DVB signal [Signal Condition]
Selects a channel and checks the DVB signal condition.
A good Signal Strength is not an indication of suitable signal for DVB reception.
Please use the Signal Quality indicator as follows :
[Signal Quality] :
Please use the Signal Quality indicator as follows :
[Signal Quality] :
t
Green bar
Good
t
Yellow bar
Poor
t
Red bar
Bad (Check the Terrestrial aerial or cable)
t
To change the channel
Channel Name
Signal Quality
Signal Strength
Bit Error Rate
Network Name
Parameter
Signal Strength
Bit Error Rate
Network Name
Parameter
70 CBBC Channel
Wenvoe
0.00E+00
802,00 MHz, 64 QAM, 6940 kS/s
DVB-C Signal Condition
90%
80%
80%
These bars show the maximum signal value of the selected channel.
Reduce the DVB-C signal [Attenuator]
If the DVB-C signal is too strong, the interference may occur. In this case set to [On] to reduce the signal automatically.
t
This function is available only for DVB-C signal.