Weed Instrument 2H09 Contact Closure Receiver Guia De Especificação

Página de 2
   
 
Connect the DIN Rail via the End Clamp (2A09) 
to protective earth ground with low impedance.  
The modules are grounded to PE when they are 
snapped onto the DIN Rail. 
Further technical information can be obtained by 
contacting Weed Instrument Co., Inc., Fiber Optic 
Products Group. 
 
Phone:  
1.800.880.9333 
  512.434.2850 
 
Fax:  
512.434.2851 
 
Email:  
fiberop@weedinstrument.com
 
 
Visit:  
www.weedinstrument.com 
Safety and Warning Information 
Important Notice - Before utilizing the product, the user should 
determine the suitability of the product for its intended use.  The 
user assumes all risk and liability in connection with such use.  
WEED INSTRUMENT'S WRITTEN WARRANTY FOR THE 
PRODUCT IS MADE IN LIEU OF ALL OTHER WARRANTIES, 
EXPRESSED OR IMPLIED WARRANTIES OF 
MERCHANTABILITY AND FITNESS FOR A PARTICULAR 
PURPOSE.  The user's exclusive remedy for breach of Weed 
Instrument's written warranty shall be the repair or replacement 
of such quantity of product which is proven to be defective.  In no 
case shall Weed Instrument be liable for any special, incidental, 
or consequential damages based upon breach of contract, 
negligence, strict liability or other legal theory. 
Weed Instrument Co., Inc. 
Round Rock, Texas, USA 
 
www.weedinstrument.com 
Publication Number: 
                RM0900129  Rev. 3/04 
Weed Instrument
2H09 
EOTec 2000 Multi-Channel 
Contact Closure  
Optical Receive Module  
Provides transfer of two channels of 
contact closure information over a 
single fiber from a partnered 2S09, 
2S36, or 2S46. 
 
For use with Multimode or        
Single-mode Glass Fiber 
ST* Compatible Fiber Connections 
1300nm Optical Wavelength
 
Installation Instructions
Fiber Optics
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
  
Connections 
FIBER RECEIVE 
PORT
 
1  2  3  4 
1  2  3  4   
1. 24VDC 
2. RETURN 
3. RETURN 
4. 24VDC 
1. NORMALLY OPEN 
2. COMMON 
3. COMMON 
4. 
NORMALLY CLOSED
 
Channel A 
Channel B 
Power 
Note:  Use shielded cable for all connections.