Optical Cable Corporation BX002DWLS9KR Fiber Optic Cable Guia De Especificação

Optical Cable Corporation reserves the right to change this specification without prior notification.

•  Ideal for installations requiring an extremely rugged and reliable cable design where maximum mechanical
 and environmental protection are necessary
•   Easiest cable to install where direct termination of connectors to sub-units and direct run to panels and

equipment is desired

•  High performance components and construction
•   UL Listed in accordance with NEC sections 770.179(b) for use in vertical  

runs in building riser shafts or from floor to floor

•  Most rugged and easy to install cable design for enterprise cabling applications
•   Core-Locked

™

outer jacket design for installation  

survivability, long-term, trouble free service

•  Ideal for use in long, vertical installations
•  2.5mm subcables can be direct-terminated with standard
 connectors (2.0mm and 2.9mm subcables also available)
•  Subcabled fiber is environmentally and mechanically protected
•  Ideal for use in point-to-point runs in adverse environments
•   Direct termination to subcable provides additional strain relief for better  

connector retention during moves, adds, and changes

•  Design is ideal for direct pulling with mesh grips
•  Cable materials are indoor/outdoor – UV, water and fungus resistant
•  Wide operating temperature range of -40°C to +85°C
•   High performance 900 µm tight-buffered coating on each optical fiber  

for environmental and mechanical protection

•   Interlocking armor can be applied to cables as an alternative to
 conduit installation
•  2 to 72 fibers

•   Direct termination to subcable may eliminate the need for patch panels and patch  

cords and reduce connector loss

•   900 µm buffer eliminates the need for costly and time-consuming installation of fanout
 kits or pigtail splices because connectors terminate directly to the fiber. See page PI-6 for
 typical termination approach.
•  High crush resistance may eliminate the need for innerduct

Operating Temperature

-40°C to +85°C

Storage Temperature

-55°C to +85°C

Installation Temperature (cable temp.)

-10°C to +60°C

Flame Retardancy

UL Listed Type OFNR (UL 1666)

and FT4 (CSA C22.2 No. 232)

Impact Resistance:

1,500 impacts

Crush Resistance:

2,200 N/cm

Flex Resistance:

2,000 Cycles