Boom Mat Sound Deadening Headliner Kit Manual Do Proprietário
Jeep Wrangler Sound Deadening Headliner
Please read before Installing:
This kit is designed to fit Jeep Wranglers equipped with factory hardtops. One person can install the front
panels over the driver and passenger seats (JK Models). However, it is recommended that a minimum of 2
people install the panels on the back part of the hardtop, as they are large (JK & TJ Models). Lay the parts in
place with the paper release liner left in place to note its position and where it will be installed. Once the
adhesive contacts a clean surface, it is extremely difficult to remove the adhesive. Be sure the part is in the
position desired before adhering it!
panels over the driver and passenger seats (JK Models). However, it is recommended that a minimum of 2
people install the panels on the back part of the hardtop, as they are large (JK & TJ Models). Lay the parts in
place with the paper release liner left in place to note its position and where it will be installed. Once the
adhesive contacts a clean surface, it is extremely difficult to remove the adhesive. Be sure the part is in the
position desired before adhering it!
Installation Instructions
1.) Remove the hardtop from vehicle and place on the floor in an inverted position
as shown in figure 1 below. – Placing the hardtop on a blanket is recommended to protect it from scratches.
as shown in figure 1 below. – Placing the hardtop on a blanket is recommended to protect it from scratches.
Figure 1 – Hardtop removed and
inverted (4 Door Shown) 2007 & Up
inverted (4 Door Shown) 2007 & Up
Figure 2 – Hardtop removed and
inverted 1997-2006
inverted 1997-2006
2.) Once the hardtop is removed, clean
the inside surface of the hardtop with
Isopropyl alcohol to ensure a good ad-
hesive bond. Note: The adhesive will not
stick properly to a dirty surface.
the inside surface of the hardtop with
Isopropyl alcohol to ensure a good ad-
hesive bond. Note: The adhesive will not
stick properly to a dirty surface.
3.) Install the foam “filler strips” in the molded ribs to ensure a smooth installation of the headliner. Without the
“filler strips”, the headliner will conform to the ridges in the top leaving an uneven appearance. Before peeling the
release liner on the strips, fit them into the ribs to properly locate them. Trim if necessary.
“filler strips”, the headliner will conform to the ridges in the top leaving an uneven appearance. Before peeling the
release liner on the strips, fit them into the ribs to properly locate them. Trim if necessary.
www.BoomMat.com
THERMAL ACOUSTIC CONTROL
THERMAL ACOUSTIC CONTROL
Figure 1
Figure 2