Simple Control Simple Cable Triple Emitter Manual Do Proprietário
Simple Cable – Triple Emitter Setup Guide
Released October 2015
Copyright © 2015 by Roomie Remote, Inc.
2
S
OFTWARE
C
ONFIGURATION
To configure a Simple Cable – Triple Emitter:
1. Open the Simple Control app, edit a room, and tap Add Device.
2. On the Add Device screen, tap Simple Blaster WiFi or Simple Blaster Ethernet.
3. On the Choose Port screen, tap the appropriate port:
1. Open the Simple Control app, edit a room, and tap Add Device.
2. On the Add Device screen, tap Simple Blaster WiFi or Simple Blaster Ethernet.
3. On the Choose Port screen, tap the appropriate port:
Ø
IR Port 1: For the device attached to the emitter cable with the 1 gray band (Emitter 1).
Ø
IR Port 2: For the device attached to the emitter cable with the 2 gray bands (Emitter 2).
Ø
IR Port 3: For the device attached to the emitter cable with the 3 gray bands (Emitter 3).
4. Finish configuring the device.
5. Return to the Add Device screen and make any necessary changes, then tap Simple Blaster
5. Return to the Add Device screen and make any necessary changes, then tap Simple Blaster
Settings.
6. On the page that loads, tap Flex Link Cable.
7. Select Infrared for the Flex Link Cable Mode.
8. Set Three IR Port Flex Link Cable to Yes and Blaster to No.
7. Select Infrared for the Flex Link Cable Mode.
8. Set Three IR Port Flex Link Cable to Yes and Blaster to No.
These are global settings for the Simple Blaster; you only have to set them once per Simple
Blaster no matter how many devices are being controlled.
Blaster no matter how many devices are being controlled.
9. Tap Save Changes, then return to the Add Device screen and tap Save.
T
ROUBLESHOOTING
•
The Simple Cable – Triple Emitter must be directly connected to a Simple Blaster. Do not
connect the Simple Cable – Triple Emitter to a Simple Cable - Triport Adapter; it will not
work correctly.
connect the Simple Cable – Triple Emitter to a Simple Cable - Triport Adapter; it will not
work correctly.
•
Configure the device being controlled by the emitter cable with 1 gray band (Emitter 1) on
IR Port 1, the device being controlled by the emitter cable with the 2 gray bands (Emitter 2)
on IR Port 2, and the device attached to the emitter cable with the 3 gray bands (Emitter 3)
on IR Port 3.
IR Port 1, the device being controlled by the emitter cable with the 2 gray bands (Emitter 2)
on IR Port 2, and the device attached to the emitter cable with the 3 gray bands (Emitter 3)
on IR Port 3.
•
Configure the Simple Blaster appropriately: Three IR Port Flex Link Cable > Yes and
Blaster > No.
Blaster > No.