Kenwood KMR-D772BT Manual Do Proprietário
40
Do the required wiring.
( 41)
( 41)
Dashboard of
your car
your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
mounting sleeve firmly in place.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into
2 Fit the catch pin on the extraction keys into
the holes on both sides of the trim plate, then
pull it out.
pull it out.
3 Insert the extraction keys deeply into the slots
on each side, then follow the arrows as shown
on the illustration.
on the illustration.
Installing the unit (in-dash mounting)
When installing without the mounting
sleeve
sleeve
1 Remove the mounting sleeve and trim plate from
the unit.
2 Align the holes in the unit (on both sides) with
the vehicle mounting bracket and secure the unit
with screws (supplied/commercially available).
with screws (supplied/commercially available).
Use only the specified screws. Using wrong screws
might damage the unit.
Hook on the top side
Orientate the trim plate
as illustrated before
fitting.
as illustrated before
fitting.
INSTALLATION/CONNECTION
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
[ terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 41)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the
[ terminal of the car battery.
5 Press
to turn on the power.
6 Detach the faceplate and reset the unit within 5 seconds. ( 3)
Part list for installation
(A) Faceplate
(C) Mounting sleeve
(B) Trim plate
(D) Wiring harness
(E) Extraction key
(F) Screws (supplied for
/
)
ENGLISH
JS_KWD_KDC_X702_KN_EN_9.indd 40
7/14/2017 2:20:41 PM