JL Audio XD700/5v2 Manual Do Proprietário

11

This option is used when deploying a pair of 
the XD700/5v2’s main channels to drive left 
channel speakers only and the other pair of 
the XD700/5v2’s main channels to drive right 
channel speakers only. 

2)  Left + Right Channel Information:  When 

bridged and fed by a stereo source signal, a 
bridged pair of the XD700/5v2’s channels will 
automatically combine the left and right input 
signals into a summed mono (left + right) 
input signal. 

The XD700/5v2’s single subwoofer channel is 

designed to deliver power into subwoofer loads 
equal to or greater than 2 ohms. It is rated for 
300W into 2 ohms, 250W into 3 ohms and 200W 
into 4 ohms (Continuous Power, RMS Method).

 

The XD700/5v2’s subwoofer outputs are 

designed to accept 16 AWG - 8 AWG wire. To 
connect the subwoofer wires to the amplifier, first 
back out the set screws on the top of the terminal 
block, using the supplied 2.5 mm hex wrench. 
Strip 1/2 inch (12 mm) of insulation from the 
end of each wire and insert the bare wire into the 
terminal block, seating it firmly so that no bare 
wire is exposed. While holding the wire in place, 
tighten the set screw firmly, taking care not to 
strip the head of the screw.

You will notice that there are two “+” positive 

connections and two “–” negative connections. 
This is to facilitate multiple subwoofer wiring.  
The two positive and two negative 
connections are connected in parallel inside 
the amplifier They are not stereo outputs. 
Connecting two subwoofers, each to one set 
of positive and negative terminals, will result 
in a parallel subwoofer connection. If only 
connecting one pair of subwoofer wires, it is 
not necessary to use both sets of connections.