Q-Logic Q-Forms Kick Panel Enclosures Manual Do Proprietário

Remove Original Kick Panel

• Carefully slide threshold plate back until kick panel lip is exposed.
• Pull up the factory door seal until the front edge of kick panel is exposed.
• Remove mounting screw cover and screw located in the center of kick panel.
• Tilt the panel downwards and remove from vehicle.

NOTE:  Always check the fit of the Q-forms into the vehicle before any cutting or modifications are done.

• Cut the speaker holes into the Q-Forms before installing them into the vehicle.
• Install the speakers into the Q-Forms after they have been installed into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface. A

die grinder or keyhole saw may also be used.

• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into mounting surface.

Be careful to center speakers in mounting surface to allow clearance for grill shell.

• Install tweeters as per manufacturer’s instructions.

Install New Q-Forms Kick-Panels  (Always predrill all mounting screw locations)

• Lay Q-forms kick panel in approximate location and connect speaker wiring.
• Install panel into permanent position previously held by original kick panel.
• Lay the rubber door seal back into permanent location.
• Reinstall factory screw into location on kick panel. Be sure front edge of

panel fits tightly against the factory door seal.

• Slide threshold plate back into factory location.
• Install grill shells by pressing snugly into woofer cavity.

QL-K1101 Included Hardware:

(2) 6" x 8" polyfill pieces
(2) 6.25" Q-grills

Estimated Installation Time: 1.5 Hrs.

9/16/98