Panamax MIW Power-Pro PFP Manual Do Proprietário

STEP 1:
Select a location close to the equipment. In the case of a flat panel 
display, the recommended location is one that is behind the device 
and hidden from view once the Plasma TV is mounted. Cut a 4” 
wide by 3 3/4” high hole in the wall for the outlet box.

STEP 2:
Run the building wire (e.g. Romex) through a rear opening in 
the outlet box (not included). No more than 1” of wire sheath 
should extend into the outlet box. 3” of wire should be able to 
extend beyond the opening of the outlet box. Install the outlet 
box in the hole.

STEP 3:
Strip building wire. Using the included wire nuts, first connect 
the ground wires - green insulated on the MlW-Power-Pro-PFP 
and bare copper on the building wire.  Then connect the neutral 
wires (white), then the hot wires (black).

STEP 4:
Neatly fold the AC wires as you install the MIW-Power-Pro-PFP 
in the outlet box and secure with the included screws.

STEP 5:
Turn the power on to the circuit. The blue Power indicator 
should light up, indicating the outlet is ready for use.

NOTES:
In the event of a hazardous voltage situation, the red Unsafe 
Voltage indicator will light up until the voltage returns to a safe 
level.

1

(Outlet boxes 

not included)

INS00840  REV E  02/10

CAUTION:
Only for use with 15 Amp circuits utilizing a minimum of 14 AWG.
Make sure the circuit is not live before installation. If you are unsure how 
to perform this task, please contact an electrician.

Signal Protection Module Usage:
Panamax In-Wall signal protection modules (sold separately), 
while not necessary for surge protection in the Max In-Wall 
Power-Pro-PFP, may be used to provide a clean looking interface 
for the signal lines. When used in the proper manner the modules 
also provide total protection to the connected equipment.