Sony E 10-18 mm f/ 4 OSS Lens Manual

2-1

SAL55200 (DT 4-5.6/55-200) (DT 55-200mm F4-5.6)

Cut and remove the part of gilt 
which comes off at the point.
(Be careful or some 
pieces of gilt may be left inside) 

• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.

Do not insert the cable insufficiently nor crookedly.

• When remove a connector, dont’ pull at wire of connector. It is possible that a wire is snapped.

• When installing a connector, dont’ press down at wire of connector.

It is possible that a wire is snapped.

• Do not apply excessive load to the gilded flexible board.

In case of the following notches or holes are located in the lens block, etc during disassembling/
assembling the lens, Use the universal wrench.

Attach the chip-A or chip-B to the universal wrench.
For the notches: chip-A
For the holes:

chip-B

Match the universal wrench to the holes or notches of the lens block, etc.

Notches

Holes

Universal wrench
J-6082-609-A

Chip-A for 
universal wrench:
J-6082-609-1

Chip-B for 
universal wrench:
J-6082-609-2

Notches

Chip-A

Chip-A

Chip-B

Chip-B

Chip

Fixed screw

Fixed screw

Chip

Match the universal wrench 
to the width of holes or notches.

Universal wrench

Holes

 Anti-diffusion agent (A-20): 

J-6082-611-A

 Grease (G-32): 

J-6082-666-A

 Adhesive bond (B-10): 

J-6082-612-A

 Grease (G-22): 

J-6082-665-A

 Grease (G-36): 

J-6082-667-A

 Adhesive bond (LOCTITE 460)
or the equivalent.

A-20

G-32

B-10

G-22

LOCTITE 460
or the equivalent

G-36

 Grease (G-37): 

J-6082-668-A

G-37