Comp X Security Products Inc 421860 Manual Do Utilizador
Oil Level Cold Check
As part of the preride inspection, perform engine oil level COLD
CHECK as follows:
CHECK as follows:
1.
With the motorcycle resting on the jiffy stand on level
ground, unthread the filler plug cap to remove the dipstick.
ground, unthread the filler plug cap to remove the dipstick.
2.
Wipe off the dipstick. Insert it back into the oil pan and
thread the plug cap completely into the fill spout.
thread the plug cap completely into the fill spout.
3.
See Figure 45. Remove the dipstick and verify the level
of the oil. The correct oil level should register between the
two arrows (1) on the dipstick.
of the oil. The correct oil level should register between the
two arrows (1) on the dipstick.
4.
If oil level is at or below the lower arrow, add only enough
oil to bring the level to the middle of the two marks on the
dipstick.
oil to bring the level to the middle of the two marks on the
dipstick.
NOTE
The reverse side of the dipstick measures oil levels on Harley-
Davidson models equipped with a sidecar. For the FLHT-
CUSE3, be sure the oil level measurement is taken on the side
of the dipstick marked with the HOT FULL and ADD QT arrows
and cross hatched scale.
Davidson models equipped with a sidecar. For the FLHT-
CUSE3, be sure the oil level measurement is taken on the side
of the dipstick marked with the HOT FULL and ADD QT arrows
and cross hatched scale.
Oil Level Hot Check
Perform engine oil level HOT CHECK as follows:
1.
Ride motorcycle until engine is at normal operating tem-
perature.
perature.
2.
With the vehicle resting on the jiffy stand on level ground,
allow engine to idle for 1-2 minutes. Turn engine off.
allow engine to idle for 1-2 minutes. Turn engine off.
3.
Unthread the filler plug to remove the dipstick.
4.
Insert it back into the oil pan and thread the plug com-
pletely into the fill spout.
pletely into the fill spout.
5.
See Figure 45. Remove the dipstick and note the level of
the oil. Add only enough oil to bring the level to the FULL
mark (2). Do not overfill.
the oil. Add only enough oil to bring the level to the FULL
mark (2). Do not overfill.
NOTE
Refer to Table 26. Use only recommended oil specified in
MAINTENANCE AND LUBRICATION, Engine Lubrication:
Synthetic Oil.
MAINTENANCE AND LUBRICATION, Engine Lubrication:
Synthetic Oil.
6.
Return the dipstick to the filler and thread-in the filler plug.
7.
Start engine and carefully check for oil leaks around drain
plug and oil filter.
plug and oil filter.
Engine oil level should be checked only when engine is at
normal operating temperature.
normal operating temperature.
138 Maintenance and Lubrication