Rainbow Aircraft Inc. V10 Manual Do Utilizador
D-15 connector pin out
The V10 transceiver provides all low frequency signal and power connections on a female
D-15 connector.
D-15 connector.
All audio connections use a common audio ground. Do not connect the audio ground to
supply ground or aircraft grounds as this may introduce interference.
Power requirement is a clean DC supply of 12V to 24V nominal. DC voltage may not exceed
28V.
A single audio output is provided able to drive a 8 ohm speaker or up to 20 standard aviation
600 ohm headsets.
A two circuit intercom circuit is provided. One circuit is intended as pilot circuit and the second
circuit is intended as passenger circuit. It is permissible to connect several microphones to
each circuit in parallel. In this case it is recommended that identical headsets are used.
Two audio grounds are provided. It is recommended to use one for microphone grounds /
auxiliary input ground and the other for headset ground.
Two PTT inputs are provided. To activate a PTT, connect the PTT input to power supply
ground or audio ground. Airframe ground may also be acceptable.
One auxiliary audio input is provided. The input can be used to connect to a music source
(CD or MP3 player) or EFIS voice alert. It is possible to connect two sources by coupling
these to the single input using 4K7 (4700) ohm resistors in each feed, joining at the auxiliary
input.
Two independent RS232 serial communications ports are provided. These are used to
connect to two independent EFIS systems for remote control of the V10 transceiver. These
ports are equivalent and are interchangeable.
One airtalk LAN communications link is provided. This is used to interconnect two V10
transceivers to form a single dual watch system.
supply ground or aircraft grounds as this may introduce interference.
Power requirement is a clean DC supply of 12V to 24V nominal. DC voltage may not exceed
28V.
A single audio output is provided able to drive a 8 ohm speaker or up to 20 standard aviation
600 ohm headsets.
A two circuit intercom circuit is provided. One circuit is intended as pilot circuit and the second
circuit is intended as passenger circuit. It is permissible to connect several microphones to
each circuit in parallel. In this case it is recommended that identical headsets are used.
Two audio grounds are provided. It is recommended to use one for microphone grounds /
auxiliary input ground and the other for headset ground.
Two PTT inputs are provided. To activate a PTT, connect the PTT input to power supply
ground or audio ground. Airframe ground may also be acceptable.
One auxiliary audio input is provided. The input can be used to connect to a music source
(CD or MP3 player) or EFIS voice alert. It is possible to connect two sources by coupling
these to the single input using 4K7 (4700) ohm resistors in each feed, joining at the auxiliary
input.
Two independent RS232 serial communications ports are provided. These are used to
connect to two independent EFIS systems for remote control of the V10 transceiver. These
ports are equivalent and are interchangeable.
One airtalk LAN communications link is provided. This is used to interconnect two V10
transceivers to form a single dual watch system.