Rainbow Aircraft Inc. V10 Manual Do Utilizador
Frequency displays
Frequencies are displayed as 6 digit numbers. The first three digits show the MHZ part of the
frequency in the range of 108 to 136. The last three digits shows the KHZ part of the
frequency. In case of the European 8.33Khz channel spacing, the frequency may be shown
rounded to the nearest KHZ:
Examples:
122.008
frequency in the range of 108 to 136. The last three digits shows the KHZ part of the
frequency. In case of the European 8.33Khz channel spacing, the frequency may be shown
rounded to the nearest KHZ:
Examples:
122.008
=
122.00833 Khz
131.533
=
131.53333 Khz
118.292
=
118.29166 Khz
The status display
The bottom section of the display contains a variable content status.
Pressing the VOL/SQL button will change between Volume and Squelch setting. If you press
the VOL/SQL button to return from squelch setting to volume setting, the squelch will briefly
open regardless of its setting (receiver static test).
the VOL/SQL button to return from squelch setting to volume setting, the squelch will briefly
open regardless of its setting (receiver static test).
V10 voltage and temperature monitoring
The V10 transceiver monitors the DC voltage at its supply terminals. The result of the voltage
measurement is used to set the output power of your transmitter and is also used to control
modulation of the transmit carrier to make optimal use of the available power.
A voltage below 11.0V will result in a “>LOW<' indication alternating with the voltage display.
Your V10 transceiver will be able to use the transmitter to below 10V. At 10V a useful 4W of
typical carrier power is available (low voltage emergency operation). Full power is achieved at
13.8V and higher input voltages while rated power is achieved at around 13V typically (varies
slightly between units and frequency tuned).
measurement is used to set the output power of your transmitter and is also used to control
modulation of the transmit carrier to make optimal use of the available power.
A voltage below 11.0V will result in a “>LOW<' indication alternating with the voltage display.
Your V10 transceiver will be able to use the transmitter to below 10V. At 10V a useful 4W of
typical carrier power is available (low voltage emergency operation). Full power is achieved at
13.8V and higher input voltages while rated power is achieved at around 13V typically (varies
slightly between units and frequency tuned).
Current audio volume
setting. Pressing the up/
down arrow key will
change the volume.
change the volume.
DC voltage level at
supply input, alternates
with internal temperature
in degrees Celcius.
Frequency entry mode:
50K tuning steps MHZ/KHZ
25K tuning steps MHZ/KHZ
25K tuning steps MHZ/KHZ
CHL Channels
LST Frequency Lists