Magicard 3663-0001 Manual Do Utilizador

ReTransfer ID Card Printer – User Manual

Error code

8191.18

Reason: While trying to feed a card from the heated roller to the transfer standby

position (where the card is over the print position sensor), and having reached the point

where the print position opto sensor had become blocked, the printer needed to move the

card for an additional short distance. However, it took too long for the card drive stepper

motor to report that it had moved by the required amount. This is due to either a bug in the

firmware, or a problem with the FPGA.

Contact your printer supplier and press

"Cancel" to power printer off.

Error code

8191.19

Reason: While trying to feed a card from the flip standby position (where the leading

edge of the card is near the eject sensor) to the transfer standby position (where the card is

over the print position sensor), and having reached the point where the print position opto

sensor had become blocked, the printer needed to move the card for an additional short

distance. However, it took too long for the card drive stepper motor to report that it had

moved by the required amount. This is due to either a bug in the firmware, or a problem

with the FPGA.

Contact your printer supplier and press

"Cancel" to power printer off.

Error code

8191.20

Reason: During the boot-up process, the printer firmware detected that the FPGA was

either unprogrammed or unresponsive to SPI commands. This can probably be remedied by

reprogramming the FPGA via the support utility, or failing that via JTAG. If neither of those

options work, it could indicate a hardware fault requiring a PCB replacement.

Contact your printer supplier and press

"Cancel" to power printer off.

Error code

8191.21

Reason: While trying to move the card from the transfer standby position (where the card

is over the print position sensor) to the heated roller, and having already reached the point

where the print position opto sensor was unblocked, the printer had to move the card an

additional short distance. However, it took too long for the card driver stepper motor to

report that it had moved by the required amount. This is either due to a bug in the

firmware, or a problem with the FPGA.

Contact your printer supplier and press

"Cancel" to power printer off.

Error code

8191.22

Reason: While trying to move the card from the encoder unit to the flip standby position

(where the card edge is by the eject sensor), the printer first had to pull the card into the

flipper from the encoder. However, it took too long for the flipper card drive motor to

report that it had moved by the required amount. This is due to either a bug in the

firmware, or a problem with the FPGA.

Contact your printer supplier and press

"Cancel" to power printer off.

Error code

8191.23

Reason: While trying to move the card from the flip standby position (where the card's

leading edge is by the eject sensor) to the flipper, and having already moved the card

forwards and just past the point where the eject sensor unblocked, the printer tried to

continue driving the card for a small additional distance using the flipper's card drive motor.

However, it took too long for the flipper's card drive motor to report that it had moved by

the required amount. This is due to either a bug in the firmware or a problem with the

FPGA.

Contact your printer supplier and press

"Cancel" to power printer off.

Error code

8191.24

Reason: While processing a job arriving via USB, the printer failed to allocate enough

memory to store the job's payload. This may be because there is a large number of jobs

Contact your printer supplier and press

"Cancel" to power printer off.