Ingenico BAS930P Manual Do Utilizador
4.5.
Battery
4.5.1.
Main characteristics
Characteristics
NimH 1500 mAh
Li-ion 1700 mAh
Capacity*
Up to 300 transactions typical
Up to 340 transactions typical
Charge
50% capacity in 2 h; full
capacity in about 8 hours
capacity in about 8 hours
50% capacity in 1.5 h; full capacity
in 4 hours
in 4 hours
Autonomy
Up to 300 h in stand by
up to 340 h in stand by
* The battery capacity depends on the model of terminal and its use
4.5.2.
Installing the battery
WARNING
Switch off the terminal prior to connecting the battery.
Switch off the terminal prior to connecting the battery.
•
Turn your terminal and unclip the cover flap battery by
pushing on the clips with your nails as shown on the picture
•
Disengage the cover
•
Take the battery pack included in the box
•
Locate the battery pack connector fool proofing
and the board connector located under the battery
compartment
compartment
•
Plug the battery pack connector on the
board according to the connector locating system and
the red wire (as shown on figure).
Verify that it locks
the red wire (as shown on figure).
Verify that it locks
•
Place the battery pack in its compartment
•
Close the battery compartment cover flap
4.5.3.
Charging the battery
When does the battery need to be charged?
•
On initial start up, charge the battery for 16 hours under the environmental
conditions stated above
•
When used daily, the terminal recharges its batteries each time it is placed on
its base . Charging is automatic
•
A completely discharged battery requires up to 8 hours for a complete
recharge according to the type of battery
Red wire