Shenzhen Anbash Technology Co. Ltd. NC335SPW Manual Do Utilizador
83
6.9.7 Resetting the Camera back to Factory Settings
Note: Do not turn off the power during the Restore function since this might corrupt the camera’s firmware.
If you ever forget your admin password or have any other reason to reset the camera to its factory settings,
please use the following procedure:
please use the following procedure:
1. Make sure the camera is powered up
2. For indoor cameras insert the tip of a paper clip in the hole at the side of the camera to press the reset
switch. You’ll feel the click when the switch engages. For outdoor cameras it is easier to use the software
reset function in the “Backup or Reset” menu. If hardware reset is needed, Unscrew the entire front part of
the camera. It is easiest to do it if you take the sunshield off first. The reset button is right under the Micro SD
card slot
reset function in the “Backup or Reset” menu. If hardware reset is needed, Unscrew the entire front part of
the camera. It is easiest to do it if you take the sunshield off first. The reset button is right under the Micro SD
card slot
3. Hold the switch down for at least 5 seconds, then let go. You’ll see the power light go off for a few
seconds. This indicates reset is in progress.
A few seconds later the camera will restart and is now at factory settings. Of course, after reset the user name and
password will both be “admin” again (Without quotes). And you may need to set current time zone as shown
below.
Setting the time and Time Zone
After a full reset you may want to make sure the correct time and time is set. This can be done
automatically if the camera has internet access and the setting is enabled as shown below:
automatically if the camera has internet access and the setting is enabled as shown below: