Shenzhen Anbash Technology Co. Ltd. NC335SPW Manual Do Utilizador
61
[Threshold] Determines at what point the alarm is triggered. A lower threshold means less motion is
needed to trigger the alarm. A higher threshold means more motion is needed to trigger the alarm.
Threshold is indicated by the blue bar when motion is detected.
needed to trigger the alarm. A higher threshold means more motion is needed to trigger the alarm.
Threshold is indicated by the blue bar when motion is detected.
[Sensitivity] Determines how easily the camera detects motion. Lower sensitivity means the camera is less
likely to detect motion. Higher sensitivity means the camera is more likely to detect motion.
likely to detect motion. Higher sensitivity means the camera is more likely to detect motion.
Note: Sliding the Sensitivity bar to the left will decrease the sensitivity of the motion detection i.e.
‘More’ movement is required to trigger the alarm.
‘More’ movement is required to trigger the alarm.
Internet Explorer can show you a live indicator for motion: When there is motion, a blue level appears
between the sensitivity and threshold slider as shown in the picture. More blue means more motion. To
trigger an alarm (and hence send out emails or upload to an FTP server etc) the detected amount of motion
needs to be larger than the threshold setting. If the blue level does not reach the threshold setting the
motion is ignored.
between the sensitivity and threshold slider as shown in the picture. More blue means more motion. To
trigger an alarm (and hence send out emails or upload to an FTP server etc) the detected amount of motion
needs to be larger than the threshold setting. If the blue level does not reach the threshold setting the
motion is ignored.
The best way to configure these settings is to adjust the settings and have someone walk in front of the
camera
camera
until your feel you are getting the required results. This trial and error method make take quite long to
get right but it’s the best way to obtain good results.
Please note: Motion detection in Internet Explorer uses the ActiveX plug-in. You
will need to install or enable this plug-in if you do not have it. To check you have
ActiveX enabled visit http://www.pcpitstop.com/testax.asp
will need to install or enable this plug-in if you do not have it. To check you have
ActiveX enabled visit http://www.pcpitstop.com/testax.asp
To reduce the chance of false alarms you would increase the threshold (move threshold slider to right) or
decrease sensitivity (move sensitivity slider to left) .
decrease sensitivity (move sensitivity slider to left) .