Zonoff Inc. EMBY001 Manual Do Utilizador

EVOLVE™

EVOLVE™ 

The Evolve Wall Switch Series replaces regular switches and dimmers and provides ON/OFF control locally and through 
TaHomA. Evolve Switches must be installed by a professional electrician as per the manufacturer’s instructions included 
with the device. As part of TaHomA’s Z-Wave mesh network, switches will act as repeaters, ensuring commands will be 
transmitted regardless of obstacles or dead spots.

NOTE: Only 1 device at a time can be included into TaHomA.

1.  Make sure the switch properly controls all connected loads before including into TaHomA. 

2.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

3.  Briefly press and release the ON/OFF button. Once the Device Finder window displays the message “Found a Device” and

the Name and Room drop down menus appear, the switch has been successfully included into the TaHomA system.

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

4.  In the Device Editor window, enter a name for the switch and assign it to a room.

5.  The switch is now fully included in the network and can now be controlled by TaHomA. Remember to activate the 

switch through TaHomA’s Device Configurator to confirm successful programming.

LED is GREEN: Connected load is OFF.

LED is OFF: Connected load is ON.

Wall Switches

NOTE: Only 1 device at a time can be excluded from TaHomA.

1.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2.  Quickly tap the ON/OFF button twice. TaHomA will remove the switch from the system and the icon will disappear from 

TaHomA. 

Pressing the ON/OFF button will act as a toggle switch and turn connected loads ON or OFF.

Wall Switches 

cont’d