Teknatool International Limited 55518RX Manual Do Utilizador
The status is as left photo
after this operation finished
after this operation finished
The status is as left photo
after this operation finished
after this operation finished
C. Connecting the Top layer two connectors of RX module as
below photo.
below photo.
This connector transmit
signal to MCU of other
controlling module
signal to MCU of other
controlling module
This connector transmit signal to LCD
Panel module
Panel module
Above steps finish hard installation.
D. the program will be loaded to MCU of RX module before SMT
production
E.
production
E.
Pressing the RX module switch, then pressing power switch of
TX watch, this operation means building handshaking relation
between RX and TX while the LED be lighted from red color to
green color, the verifying method is to up/down the speed switch,
the LCD display will show changed data.
between RX and TX while the LED be lighted from red color to
green color, the verifying method is to up/down the speed switch,
the LCD display will show changed data.