Xerox 003R06709 Manual Do Utilizador

• Coarse dither patterns at lower resolutions are best for billboards. High-resolution error-diffusion can produce a streaking 

effect on billboards when viewed at a distance. Panels should be created with a minimum 2–inch (50 mm) internal bleed 
and a 2–inch (50 mm) external bleed. 

• Panel size should not exceed maximum width one person can handle 48–inch wide (1220 mm) but is usually determined by

standard as 42 inch wide (1067 mm).

• PRINTER SPEED: Choose the appropriate “Print Mode” for the application and/or media. Print with pigment inks.

• Carefully label panels for easier installation (ex: 1 of 4, 2 of 4, etc.).

• The whole print may be wetted with paste immediately before application. Use a recommended billboard paste, but do not add

alcohol or glycol as this dissolves inks. When applying, use only light pressure to avoid damaging the print. 

• POSTING: Installer should follow standard posting procedures for paper stock. Ensure mounting surface is clean, dry and free

of rust and debris. Loose or peeling portions of a previous layer should be removed and rough spots should be 
feathered by sanding. Unfold wet panel. Align top and edge to be joined. Light pressure with a soft smoothing brush or
squeegee should be used to smooth wrinkles and air pockets. Work from the center toward the edges.

Application Ideas and Procedures

Xerox Wide Format Supplies Applications Guide 

Version 2.0; April 2005

72

The display size of billboards, as well as the appropriate design, will vary. Quick turnaround and image flexibility are
a key advantage of digital printing methods. The final image quality depends not only on prepress and production, but
also proper pasting and installation.

Most limitations in expected life of billboards is due to pasting methods. Flagging, chalking, and other problems are
due primarily to installation procedures.

Bus shelters, subway advertisements, multi-paneled murals, billboards, event signage and display.