Arcadyan Technology Corporation WN4501DARC Manual Do Utilizador
51
Appendix
Gigaset USB Adapter 54 / English / A31008-E505-B104-1-19 / appendix.fm / 26.02.2004
The Gigaset USB
Adapter 54 does
not work properly
Adapter 54 does
not work properly
You have checked all of the causes specified above, and still no
communication is possible.
communication is possible.
ì
Deinstall the software and install it again as described in
Chapter "Installing the Gigaset USB Adapter 54" on page 7.
Chapter "Installing the Gigaset USB Adapter 54" on page 7.
You cannot
establish a
connection to the
Access Point
establish a
connection to the
Access Point
If you cannot set up a connection between your Gigaset USB
Adapter 54 and an Access Point, try one or more of the
following:
Adapter 54 and an Access Point, try one or more of the
following:
ì
Make sure that the physical connection of the Access Point
operates reliably.
operates reliably.
ì
Make sure that the same SSID is used for the Gigaset USB
Adapter 54 and the Access Point.
Adapter 54 and the Access Point.
ì
Check whether the security settings configured for the
Gigaset USB Adapter 54 match those for the Access Point,
e. g. the same key for WEP encryption.
Gigaset USB Adapter 54 match those for the Access Point,
e. g. the same key for WEP encryption.
ì
Check whether your access to the Access Point is blocked by
other security measures, e. g. by a MAC filter or filter for
IP addresses.
other security measures, e. g. by a MAC filter or filter for
IP addresses.
ì
Make sure that the IP address and the subnet mask are
correctly configured in the IP Settings tab.
As a rule, it is necessary to assign dynamic IP addresses
when operating a network in infrastructure mode.
correctly configured in the IP Settings tab.
As a rule, it is necessary to assign dynamic IP addresses
when operating a network in infrastructure mode.
Installation
cancelled under
Windows 2000
cancelled under
Windows 2000
If the following error message appears when installing the
Gigaset USB Adapter 54 under Windows 2000: "1608: Unable
to create InstallDriver instance" and the installation is cancelled,
the cause is that the Microsoft Network Client component is
missing.
To install the Microsoft Network Client:
Gigaset USB Adapter 54 under Windows 2000: "1608: Unable
to create InstallDriver instance" and the installation is cancelled,
the cause is that the Microsoft Network Client component is
missing.
To install the Microsoft Network Client:
ì
Select Start > Settings > Control Panel > Network and
Dial-up Connections.
Dial-up Connections.
ì
Right-click on LAN Connection, and select Properties.
ì
Then click on the following Install > Client > Add > Client
for Microsoft Networks > OK.
The Microsoft Network Client component is now installed.
for Microsoft Networks > OK.
The Microsoft Network Client component is now installed.
ì
Restart your PC to apply the change.
ì
Install the software, see Chapter "Installing the Gigaset USB
Adapter 54" on page 7.
Adapter 54" on page 7.
Problem
Causes and remedies