Ruckus Wireless VF7XX1 Manual Do Utilizador

14

Ruckus Wireless MediaFlex 7811 Access Point

If you cannot connect to the 7811, follow this startup sequence:

1. Unplug the 7811’s power adapter.

2. Plug in the 7811’s power adapter.

3. Connect the 7811 (through the WAN port) to your DSL modem or gateway.

4. Connect your computer to your DSL modem or gateway, and then set the IP address of your computer by 

5. On your PC, open a browser window. Enter the default IP address of the 7811 that appears on the label at the 

bottom of the 7811. When the login screen appears, enter the username and password shown on the label at 
the bottom of the 7811.

6. Choose Configuration :: Device. Verify that your computer’s wireless network settings match that of the 

7811.

7. Check the LED status lights to verify correct operation.

• Make sure you are using the correct power adapter supplied by Ruckus Wireless.

• Make sure the Power LED is lit.

 

If it is not lit, make sure that the power cord is properly connected to 

the 7811, and that the AC power adapter is properly connected to a functioning power outlet. If the 
problem persists, you have a hardware problem and should contact technical support.

• Make sure your WAN Connectivity LED is lit. Make sure that the Ethernet cable connections are 

secure at the 7811 and your computer. The WAN Connectivity LED on the 7811 indicates link when 
the adapter is fully seated in the port.

• Make sure the Wireless Device Association LED is either steady or flashing Green

.

 If not lit, the 

Wireless settings may be incorrect between the 7811 and your computer. If necessary, reset the 7811 
to its factory defaults

If you forgot what IP address or security settings you assigned to the 7811, you can reset it to factory defaults 
by inserting the end of a paper clip into the reset button hole located on the back of the unit. Press and hold 
the reset button for at least eight (8) seconds. Then you can connect to the 7811 using the default network 
settings.