C-Com Corporation 56AZBT Manual Do Utilizador
5.3 AT\ Commands
- Error correction control
\An
*
Maximum MNP block Size
\A0 64 characters maximum block size
\A1 128 characters maximum block size
\A2 192 characters maximum block size
\A3 256 characters maximum block size
Result codes:
OK n=0-3
Error Otherwise
Related S-Reg: S<basereg+1> of V.42 registers
\Bn
Transmit break to remote (-)
In non-error correction mode, the modem will transmit a break signal to the remote
modem with a length of n*100ms. If a number above 9 is entered, 9 is used.
Result codes:
OK if connected in data modem mode
Error if not connected or if connected in fax modem mode
\Kn
Break Control (-)
Controls the response of the modem to a break received from DTE or a remote modem
or the \Bn command.
The behavior parameter is written to Sxx
\K0 Enter on-line command mode, no break sent to remote modem
\K1 Clear data buffers and send break to remote modem
\K2 Same as 0