BMI Technologies Inc. RFVI Manual Do Utilizador
DRAFT G FORCE PLUS RF Instruction Manual
Doc #RF1 Rev.9
49
Apr/08
VEHICLE OPERATION
The sections below describe the various states, conditions and operating requirements of a Vehicle equipped with
a Vehicle Monitor.
VEHICLE STARTUP
1. Turn the Vehicle ignition on.
2. If the Vehicle requires a Diagnostic Delay (setting from the Vehicle’s Authorization Group), the Vehicle
Interface will display “VEHICLE SYSTEM CHECK PLS WAIT..”.
3. The Vehicle Interface will display “OPERATOR LOGIN PRESENT CARD” after the expiry of the
Diagnostic Delay.
OPERATOR LOGIN
1. Present a valid Operator Card to the Vehicle Interface when it displays “OPERATOR LOGIN
PRESENT CARD”. This message will alternate with “BATTERY (STATE OF CHARGE)” if the
Vehicle’s Authorization Group settings require Battery Monitoring.
Vehicle’s Authorization Group settings require Battery Monitoring.
2. If no Operator Card is presented within three seconds, the Vehicle Interface buzzer will sound, as will the
horn if programmed to do so.
3. The Vehicle Interface will indicate a Card has been validated with a single beep, or by stopping the
sounding buzzer (and horn).
4. Remove the Card from the Vehicle Interface. It will display “LOGIN APPROVED”. “LOGIN
APPROVED CARD EXPIRY SOON” will display if the System Settings indicate a Card Expiration
Warning is required.
Warning is required.
Messages other than “LOGIN APPROVED” indicate why a Card could not be validated. The Vehicle
Interface reverts to “OPERATOR LOGIN PRESENT CARD” after five seconds.
“LOGIN DECLINED CARD INVALID”
Interface reverts to “OPERATOR LOGIN PRESENT CARD” after five seconds.
“LOGIN DECLINED CARD INVALID”
Not an Operator or Lockout Card