EnOcean GmbH EOSC01 Manual Do Utilizador

Occupancy Sensor - Ceiling Mounted

Installation Guide

 ▪

Occupancy Sensor

 ▪

2 screws, 2 wall anchors

 ▪

Wire bracket

The ceiling-mounted Occupancy Sensor saves energy and adds 

convenience by accurately detecting when an area is occupied 

or vacant. 
This device is wireless, powered by indoor light, and uses a pas-

sive infrared (PIR) sensor to detect motion. The occupancy sen-

sor transmits RF signals that control lighting, HVAC and outlets 

to manage energy more efficiently.
Features Include: 

 ▪

Sends wireless messages to other devices whenever motion 

is detected

 ▪

Harvests ambient solar energy to power the sensor and wire-

less communication

 ▪

Mounts easily on any ceiling material 

 ▪

Works with other sensors for enhanced occupancy tracking

 ▪

Built-in tests to confirm operation at installed location

 ▪

Supplemental battery or alternative power supply options for 

extreme low-light conditions

Power Supply Indoor light energy harvesting 

(Optional) Supplemental battery or 

2-wire connector for external power 

or remote solar cell (3-5VDC)

Transmission Range 80 ft. (25 m)

Radio Frequency EnOcean 315 MHz,  

ISO/IEC 14545-3-10 standard

Light Required to  

Sustain Operation

50 lux for 30 transmissions/hour 

100 lux for 60 transmissions/hour

Charge Time  

before Linking 

2 minutes @ 50 lux

Charge Time for  

Full Charge 

3 hours @ 200 lux (after startup) 

6 hours @ 200 lux (cold start)

Operating Life in Dark-

ness (after full charge)

48 hours

EEP (EnOcean  

Equipment Profile)

A05-07-01

Heartbeat Intervals  

(for gateway systems)

2 - 12 mins., randomized

Dimensions 2.35” H x 6.3” W x 1.47” D 

(60 mm x 160 mm x 37 mm)

Weight 4.4 oz. (125 g)

Environment Indoor use only

14° to 104°F (-10° to 40°C)
20% to 95% relative humidity 

(non-condensing)

Agency Compliance FCC, IC

Functional Description 

If occupation is detected by the permanently active PIR sensor, 

a radio telegram indicating the occupied status will transmit 

immediately. An internal timer starts to run with a variable timer 

length. The timer value may vary between 60 and 300 seconds, 

depending on the light level.  No radio telegrams will be sent 

out when the timer is counting down.
After the timer has finished the countdown, the unit will trans-

mit again if occupancy was detected during the countdown time 

period. If occupancy was not detected, the unit will transmit a 

heartbeat signal - sending the unoccupied status with a ran-

dom timing of 2 to 12 minutes. There are two buttons which 

allow entrance to a “Walk” or “Light-level” test mode.  These 

test modes are for installation purposes only and will be exited 

automatically after 3 minutes.

 ▪

Power drill, 3/16” bit

 ▪

Screwdriver

 ▪

Light meter

 ▪

Battery (CR2032) for testing

Page 1