Revolabs 01-FUSION4 Manual Do Utilizador

 
Step 

1 

   Step 

2 

 

Plug both RCA connectors on one end of Cable C into Tandberg video-

station <Audio Out>, then plug one RCA connector on the other end, 
(red or black) into the Fusion Base Station <Conf In>.  The other 
RCA connector is not used.  

Plug one XLR connector of Cable D, XLR to XLR, into Tandberg video-

station <Mic 1 Input> and the other RCA connector into the Fusion 
Base Station <Conf Out>. 

 

 
 

• 

TableTop microphones should be centered on the table with the integral 
grill pointed toward the users (uni-directional), or centrally located 
between users (omni-directional), from 2 to 5 feet (.75 to 1.75m) away. It 
is always better to be as close to the person speaking as possible, but avoid 

placing the microphone where it might be blocked by equipment or 
meeting paperwork. Also do not place microphones too close to an audio 
or video conference speaker to avoid echoes. 

• 

With the microphone in position, un-mute the microphone by pressing and 
releasing the Mute button (confirm by viewing flashing GREEN LED).  

• 

To turn microphone off, return the microphone unit to the Charger Base 
or press and hold the Mute button for ~10 seconds until the LED turns 
solid RED and release button. 

• 

If the microphones are placed too far from the Base Station (~100 feet or 
30 meters) the connection will be dropped (LED flashes all colors) and the 
microphone will mute. After 15 seconds the microphone will beep 5 times, 
and will continue beeping every 30 seconds to indicating it’s out of range.  

• 

Move the microphone closer to the Base Station and the connection will 
automatically be re-established to its original state, and the beeping will 
cease. If not, the microphone will continue beeping until it turns off in 
about 15 minutes.