Mitel Deutschland GmbH 68635RFP36U-01 Manual Do Utilizador
SIP-DECT OM System Manual
182
•
Resolution: Select a resolution for the video device. Higher resolutions require more bandwidth when
watching the video image in the OM Locating application. Note, that not all video devices support all
available resolutions. Default: “VGA (640 x 480)”.
available resolutions. Default: “VGA (640 x 480)”.
•
Frame rate: Select a frame rate (2-10 frames per second). Higher frame rates require more
bandwidth when watching the video image in the OM Locating application.
•
Rotation: Select the video image rotation (0, 90, 180, or 270 degrees).
6.9.2 VIEWING VIDEO DEVICE DETAILS
You can view the configuration of a video device in
monitor mode. Proceed as follows:
1 Select the appropriate video device in the video devices table.
2 In the task bar on the right of the Video devices panel click on the Show details command.
2 In the task bar on the right of the Video devices panel click on the Show details command.
The video device detail panel opens (see 6.9.1).
3 Click Cancel to close the video device detail panel.
6.9.3 DELETING VIDEO DEVICES
Deleting video devices is only possible in
Configuration Mode. To delete one or more existing video
devices proceed as follows:
1 Select the appropriate video device(s) in the video devices table by activating the corresponding
1 Select the appropriate video device(s) in the video devices table by activating the corresponding
checkbox(es). Note that you can only delete disconnected video devices.
2 In the task bar on the right of the Video devices panel click on the Delete command.
The
Delete selected video devices(s) dialog opens showing a confirmation prompt.
3 Confirm the displayed prompt with OK.
6.9.4 FILTERING VIDEO DEVICE TABLE
You can filter the list of video device entries shown in the video devices table by using a filter.
1 In the task bar on the right of the Video devices panel click on the Filter command.
1 In the task bar on the right of the Video devices panel click on the Filter command.
The
Filter dialog opens.