Mitel Deutschland GmbH 68635RFP36U-01 Manual Do Utilizador
Configuration and Administration
307
video device, the
RFP ID is the identifier of the RFP the video device is plugged in, USB path is an
identification of the plug-in position and
State is the actual state of the video device.
7.28 TERMINAL VIDEO
As of SIP-DECT 5.0, Mitel 600 DECT phones support video streams from cameras connected to SIP-
DECT RFP 35/43 base stations. When a user has video stream permission, he can choose in the
system menu from a list of cameras to connect.
DECT RFP 35/43 base stations. When a user has video stream permission, he can choose in the
system menu from a list of cameras to connect.
Video Streaming is only available when the DECT phone is connected to a RFP 35/36/37/43 and the
permission is set for the site and the DECT phone.
permission is set for the site and the DECT phone.
Video streams are treated like a call by the DECT phone, which require two (of eight) air channels on the
RFP for each stream. The DECT phone can also perform handover between RFPs with an active video
connection.
RFP for each stream. The DECT phone can also perform handover between RFPs with an active video
connection.
A video connection is automatically terminated by the system in case that any related capability (e.g.
video stream permission) is changed.
video stream permission) is changed.
7.28.1 TECHNICAL DETAILS
Terminal video resolution and framerate are independent from the configured camera resolution and
framerate.
framerate.
The resolution of the terminal video stream is automatically downscaled to 176 * 144 pixels (QCIF) with a
frame rate of approximately 2 frames per second.
frame rate of approximately 2 frames per second.
The resulting overall delay is below 2 seconds.
The maximum number of simultaneous terminal video streams per camera is restricted to 10.
7.28.2 OMP CONFIGURATION STEPS
Connection and configuration of cameras is similar to the already known steps referring to the locating
application. Special steps necessary for terminal video are:
application. Special steps necessary for terminal video are:
• Enable all sites, which have the technical capability (only RFP 35/36/37/43
are referred to it), via
OMP for terminal video.
• Enable via OMP (
DECT Phones -> Users -> Additional services) by setting the “Video stream
permission” for those users who are allowed to use this feature.