AIR802 LLC AP25N01 Manual Do Utilizador
AP25N01 User Manual
67
when too many data frames are re-sent, thus if the timeout is set too short or too long, it
will result poor connection and throughput performance.
will result poor connection and throughput performance.
Changing the ACK Timeout value will change the Distance to the appropriate distance
value for the ACK Timeout.
value for the ACK Timeout.
Auto
Adjust control and enable the ACK Timeout Self-Configuration feature. If enabled, the
ACK Timeout value will be derived dynamically using an algorithm similar to the
Conservative Rate Algorithm described above. It is not recommended to use the Auto
Adjust option for long range links if the signal level is low or the high level of interference
is present.
ACK Timeout value will be derived dynamically using an algorithm similar to the
Conservative Rate Algorithm described above. It is not recommended to use the Auto
Adjust option for long range links if the signal level is low or the high level of interference
is present.
If two or more stations are located at considerable distance from the Access Point, the
highest ACK Timeout for the farthest station should be set at the AP side. It is not
recommended to use the Auto Adjust option for Point-to-Multipoint connections as it will
not warrant highest network performance in all the use cases.
highest ACK Timeout for the farthest station should be set at the AP side. It is not
recommended to use the Auto Adjust option for Point-to-Multipoint connections as it will
not warrant highest network performance in all the use cases.
Signal Strength LED Settings
LED Thresholds Configuration
The signal strength LEDs on the device can be made to light when received signal
levels reach the values defined in the following fields. This allows a technician to easily
deploy a CPE without logging into the unit (i.e., for antenna alignment operation).
levels reach the values defined in the following fields. This allows a technician to easily
deploy a CPE without logging into the unit (i.e., for antenna alignment operation).
Signal LED Thresholds specify the marginal value of signal strength (dBm) that will
switch on LEDs indicating signal strength:
switch on LEDs indicating signal strength:
LED 1 (Red), LED 2 (Yellow), LED 3 (Green) and LED 4 (Green) will switch on when
the Signal Strength reaches the value set in the associated entry field.
the Signal Strength reaches the value set in the associated entry field.
Configuration example: if the signal strength fluctuates around RSSI 15-30, the LED
thresholds can be adjusted to the RSSI values 15, 20, 25, 30.
thresholds can be adjusted to the RSSI values 15, 20, 25, 30.