Brivo Systems Inc. ACS300-1 Manual Do Utilizador

Brivo ACS300 Installation Manual

Page 14

Rev 1

Powering and Testing Procedures

WARNING: Power Precautions (if not using Power over Ethernet)

BEFORE POWERING UP THE ACS300, CHECK THE FOLLOWING
CONNECTIONS. MAKE SURE THAT:

• The transformer is NOT plugged into the 120 VAC outlet.

Power up the ACS300

1. Plug the CAT 5 cable into the LAN/PoE connector.

WARNING: Powering Electronic Strikes and Latches

DO NOT POWER ELECTRONIC STRIKES AND LATCHES WITH THE
POWER SOURCE USED TO POWER THE ACS300 UNIT; DOING SO
WILL CAUSE DAMAGE TO THE ACS300 UNIT. USE ONLY A UL LISTED
BURGLAR ALARM OR ACCESS CONTROL SYSTEM TO POWER
ELECTRONIC STRIKES AND LATCHES.

2. Check ALL power indicators:

a) Check the ACS300 to confirm that the green power rail LED lights are on,

indicating that AC power is being supplied to the board and that the board is
producing 12 VDC power.

b) Check the ACS300 to confirm that the Status and Active Lights have come on.

ACS300 Status and Active Lights

c) If any of these power indicators are not correct (i.e., the green power rail LED

lights do not come on or the blue Status and Active LEDs do not begin blinking,
check the connections from the ACS300 to the network connection. If all
connections are good but there is a still a problem with the power indicator,
contact Technical Support.