i-SENS Inc. BM001 Manual Do Utilizador
page 3 of 6
separation
with the antenna while this end product is installed and operated.
The end user has to be informed that the FCC radio-frequency exposure guidelines for an
uncontrolled environment can be satisfied. The end user has to also be informed that any
changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate this equipment.i f the size
Of the end product is smaller than 8x10cm,then additional FCC part15.19statement is required to
be available in the users manual; This device complies with Part15 of FCC rules.
with the antenna while this end product is installed and operated.
The end user has to be informed that the FCC radio-frequency exposure guidelines for an
uncontrolled environment can be satisfied. The end user has to also be informed that any
changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate this equipment.i f the size
Of the end product is smaller than 8x10cm,then additional FCC part15.19statement is required to
be available in the users manual; This device complies with Part15 of FCC rules.
IC Information
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s).
L'opération est soumise aux deux conditions suivantes:
L'opération est soumise aux deux conditions suivantes:
(1) cet appareil ne peut causer d'interférences, et
(2) cet appareil doit accepter toute interférence, y compris les interférences qui peuvent
causer un mauvais fonctionnement de l'appareil.
The end product must be labeled to display the Industry Canada certification number of the
module.
module.
Contains transmitter module IC: 21003-BM001
Le dispositif d'accueil doivent être étiquetés pour afficher le numéro de certification d'Industrie
Canada du module.
Canada du module.
Contient module émetteur IC : 21003-BM001
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.
This module is intended for OEM integrator. The OEM integrator is still responsible for the
IC compliance requirement of the end product, which integrates this module.
20cm minimum distance has to be able to be maintained between the antenna and the
users for the host this module is integrated into. Under such configuration, the IC RSS- 102
radiation exposure limits set forth for an population/uncontrolled environment can be
satisfied.
IC compliance requirement of the end product, which integrates this module.
20cm minimum distance has to be able to be maintained between the antenna and the
users for the host this module is integrated into. Under such configuration, the IC RSS- 102
radiation exposure limits set forth for an population/uncontrolled environment can be
satisfied.
The final end product must be labeled in a visible area with the following " Contains TX IC :
21003-BM001”
21003-BM001”
User Information
This device complies with FCC & IC radiation exposure limits set forth for an uncontrolled
environment. This device should be installed and must not be co-located or operating in
conjunction with any other antenna or transmitter.
This device is intended only for OEM integrators under the following conditions:
This device complies with FCC & IC radiation exposure limits set forth for an uncontrolled
environment. This device should be installed and must not be co-located or operating in
conjunction with any other antenna or transmitter.
This device is intended only for OEM integrators under the following conditions: