HARRIS CORPORATION TR-0054-E Manual Do Utilizador

 

121 

The P7300 series radios provide audible Alert Tones or “beeps” to indicate the various operating 
conditions (see Table 11-4). 

Call Originate 

one short mid-pitched 

Call Queued 

one high-pitched 

Autokey one 

mid-pitched 

System Busy 

three low-pitched 

Call Denied 

one low-pitched 

Carrier Control Timer 

five high-pitched/one long low-pitched 

Low Battery 

one low-pitched/one short mid-pitched 

TX Low Battery Alert 

one low-pitched 

 

1.  Power ON the radio by rotating the POWER ON-OFF/VOLUME knob clockwise. A short alert 

signal (if enabled through programming) indicates the radio is ready to use.  

2.  The display shows the last selected system and group or a default system and group (depending on 

programming).  

3.  Adjust the POWER ON-OFF/VOLUME knob to the desired volume level.  

4.  Select the desired system and group. The display indicates the current system and group names.  

5.  The radio is now ready to transmit and receive calls. 

METHOD 

1: 

 

From the Control knob: If system selection is programmed to the
System/Group/Channel control knob, select a system by turning the knob to 
the desired system number position (1-16).  The display registers the new 
system name on line one.  The 

button can be programmed to provide 

access to a “2

nd 

bank” of 16 system number positions (17-32). 

METHOD 2:  

From the keypad: If system selection is programmed as the primary function 
of 

 and

 

select a system by pressing 

 or

 

to scroll through the 

system list. The display registers the new system name on line one.  

METHOD 3:  

(P7370 model radios only) Direct Access: Press 

  to enter the system 

select mode. Press the numeric key, which is mapped to the desired system.
Press 

.  The radio will move to the selected system.