HARRIS CORPORATION TR-0054-E Manual Do Utilizador
MM-013994-001, Rev. Ap1
135
If a response is made by pressing the PTT to the call prior to the programmed call-back time-out, the call
will automatically be directed to the originating unit. If a response is not made before the call-back time-
out, the radio will return to normal receive display, and
will automatically be directed to the originating unit. If a response is not made before the call-back time-
out, the radio will return to normal receive display, and
*WHC*
will appear on the first line of the LCD.
To respond after the call-back time-out, press the
key. The radio's display will show the callers ID on
the first line and
WHCI=1
on the second line. Pressing the PTT button at this point will initiate an
individual call back to the original caller.
The radio stores the IDs of the last 10 callers in the Calls Received List as shown. Individual calls are
stored in the top half of the list (1-10) and Group calls are stored in the bottom half of the list (1-10). The
most recent call is stored in position 1, the second most recent call is stored in position 2, etc.
stored in the top half of the list (1-10) and Group calls are stored in the bottom half of the list (1-10). The
most recent call is stored in position 1, the second most recent call is stored in position 2, etc.
Figure 11-13: Calls Received Lists
To access the Calls Received List, press the
key twice. Use the
or
buttons to scroll through
the list. Pressing the
key will display the time elapsed since the call was received. After pressing
the display will appear similar to Figure 11-14.
Figure 11-14: WHC Individual Call Display
Pressing the PTT will initiate an individual call to the displayed logical ID. Powering the radio OFF and
ON will clear this list.
ON will clear this list.
11.20.2 Sending an Individual Call
11.20.2.1 Pre-Stored Individual Calls
The following procedures describe how to initiate and complete a Pre-Stored Individual Call.
P7370 Model Radio
1. To select a pre-stored individual phone number, enter the individual call mode using the
key. is
displayed. Then scroll through the list of stored numbers using the
or
keys.
2. Press the PTT button; when the radio is clear to transmit, turns ON, turns OFF and the channel
access tone sounds. Line one shows the called individual's name if found in the list of stored