Vogel's PPL 2525 Folheto

Página de 4
 
 
 
 
In most situations you would like to control 
the  projector  lift  system  by  an  external 
control  option.  This  can  be  an  AMX  or 
Crestron  automation  system,  a  simple  wall 
switch or a wireless remote control. 
All  PPL  lift  systems  are  standard  equipped 
with a control box offering 5 in and outputs 
for  remote  control.  This  offers  maximum 
flexibility to control the lift system. 
 
Remote 1 and 2 inputs for all functions 
The  two  parallel inputs  remote  1 and  2 can  be 
used  for  two  separate  remote  controls.  This 
can  be  the  standard  service  remote  control,  a 
control  system  like  AMX  or  Crestron  or  a  wall 
switch.  These  inputs  operate  with  open 
contacts  that  switch  5V  to  ground  and  can 
operate all lift functions. 
 
Two 12V outputs 
Two  3,5mm  jack  outputs  can  give  12V  at 
various  moments.  These  moments  can  be  set 
via a DIP switch block. These 12V outputs can 
be  used  to  control  a  projection  screen  and/or 
the power supply of the projector. The 12V can 
be  given  for  example  when  the  lift  starts 
descending  and  in  show  position  and  switch 
back to 0V at ascending and in top position.  
 
12V input 
A 3,5mm jack input makes it possible to control 
the lift system with an external 12V. 12V on this 
input  will  make  the  lift go  to  Show  position,  0V 
will make the lift go to Top position. 
 
 
Advantage: 
o  Standard  you  have  maximum  flexibility 
for  external  control  and  operation  of  the 
lift system 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Additional 
“service”  position 
Most lift systems offer only two height positions, 
Home and Show. Vogel’s PPL lift systems offer 
third position: Service. This position will bring 
the projector all the way down to a comfortable 
(programmable)  height  to  do  quick  and  easy 
projector service. 
 
Remote position setting 
As the height positioning is electronic, it can be 
set  remotely.  There  is  no  need  to  climb  up  to 
the  lift  system  to  set  or  adjust  the  height 
positions. Just  set  it  from  ground  level  or  even 
in  a  control  room  if  you  are  using  a  control 
system. 
 
Very accurate 
The  electronic  height  positioning  is  working 
with  an  infra  red  optical  sensor.  This  sensor  is 
counting  steps  when  the  lift  is  moving  and  is 
reset  every  time  the  lift  is  in  top  position.  This 
guarantees  a  very  accurate  height  positioning. 
The  infra  red  sensor  is  not  sensitive  for  dust, 
which is important for use above a false ceiling. 
 
 
 
Advantage: 
1.  Continuous  accuracy,  the  projector 
image  is  always  in  the  exact  same 
position. 
2.  Remote  position  setting  from  ground 
level. 
3.  Three height positions 
 
 
 
 
 
 
External controls 
 
Three electronic height positions