Wistron Corporation TXE01 Manual Do Utilizador
. Wistron 3D RF Tx Module and Tx Dongle
Page 7 27 October 2011
3D RF Tx Dongle Block Diagram
1.3.3 Subsystem
3D RF Tx Module
Connector:
4 pin connector: System power source and 3D trigger signal.
Pin1
3.3V
Pin2
3D trigger signal
Pin3
paring
Pin4
GND
Electronics module:
Microprocessor.
There shall be GPIO that is used to trigger 3D signal.
Immediately via 2.4G RF wireless output the 3D signal to radio.
Firmware and paring ID upgrades support.
Immediately via 2.4G RF wireless output the 3D signal to radio.
Firmware and paring ID upgrades support.
Trigger signal.
Voltage : 3.3V +- 5%
Pulse
Pulse
2.4G RF circuitry
Connectivity supporting: frequency hopping with 3 channels.
RF performance: 10 meters
1 3D RF Tx module can support up to 10 3D RF Rx module at one time
RF performance: 10 meters
1 3D RF Tx module can support up to 10 3D RF Rx module at one time