u-blox Malmo AB 071902 Manual Do Utilizador

Utfärdare / Issued by

Datum / Date

Beteckning / Ref.

Sida / Page

Andreas Hörjel, Mats Andersson

2005-06-08

cBProject-0403-01 (23)

61 (61)

Ärende / Subjekt

Godkänd av / Approved by

BT IO Functional Description

Template update: 00-12-01

6.2 IC Compliance

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.

This device has been designed to operate with an antenna having a maximum gain of 9 dB. Antenna
having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna
impedance is 50 ohms

To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for
successful communication.

6.3 Safety

The unit must be supplied by a limited power source in according to EN 60950-1.

6.4 Label and manual requirements for the End Product

For an end product using the BT Unit there must be a label containing, at least, the following
information:

This device contains
FCC ID: PVH071902
IC: 5325A-0719X

The label must be affixed on an exterior surface of the end product such that it will be visible upon
inspection in compliance with the modular approval guidelines developed by the FCC.

Where the module will be installed in final products larger than 8 cm x 10 cm following statement has
to be placed ONTO the device.

“This device complies with Part 15 of the FCC Rules.

In case, where the final product will be installed in locations where the end-consumer is not able to
see the FCC ID and/or this statement, the FCC ID and the statement shall also be included in the end-
product manual.