Wilson Electronics LLC 2B2725 Manual Do Utilizador
5
6
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Mon.- Fri. Hours: 7 am to 6 pm MST.
5
6
Installing a Wilson electronics Outside Antenna in a Building
Follow the specific antenna instructions included with the Outside Antenna (sold separately except for
Follow the specific antenna instructions included with the Outside Antenna (sold separately except for
certain kits). These instructions assume that you are using a Wilson Electronics Mini-Magnet Mount
Antenna and the optional suction-cup window bracket.
To receive the best signal, select a window on the side of your building where your outside signal is
To receive the best signal, select a window on the side of your building where your outside signal is
the strongest.
Attach the suction-cup bracket to the inside of a window so that the cable will reach
the location of the Sleek. Place the bracket as high on the window as possible for
best performance.
Once the bracket is in place, attach the magnet base of the antenna to the flat
Once the bracket is in place, attach the magnet base of the antenna to the flat
surface of the bracket.
Note: The antenna must be installed vertically. Signal
performance will be degraded if the antenna is not vertical.
The Wilson Electronics Sleek may be placed in any convenient indoor location, such as a desk or
tabletop. The cell phone must be in the cradle and use a Bluetooth
™
headset or wired hands free device
for voice communications.
Attaching the Antenna
Once you have selected the location for the Sleek, run the cable from the Outside Antenna and attach it
to the SMA connector on the bottom of the Sleek.
Note: The Sleek and the Outside Antenna must have a minimum separation of 3 feet to prevent oscillation.
Installing the Wilson Sleek Signal Booster in a Building
In-Building Installation
Outside Antenna
communications with
cell tower
Sleek amplifies signal to &
from cell tower
Sleek powered through Surge
Protector Power Strip
IMPORTANT NOTICE
It is very important to power your Signal Booster using
•
a surge protected AC Power Strip with at least a
1000
Joule rating.
Failure to do this will void your warranty in the
•
event of
a power surge or lightning strike.
Adapter Note:
For optimal performance and to maintain a secure connection, we recommend
attaching the included velcro tab. If adapter becomes lose in the port, gently
squeezing the adapter end will restore a snug fit.