Wilson Electronics LLC 460004 Manual Do Utilizador

ENGLISH

To uphold compliance with network protection standards, all active cellular devices must maintain 

at least 6 feet of separation distance from Panel and Dome antennas.

Connecting the Signal Booster directly to the cell phone with use of an adapter will damage the cell 

phone.

Use only the power supply provided in this package.  Use of a non-Wilson Electronics product may 

damage your equipment.

   The Signal Booster unit is designed for use in an indoor, temperature-controlled environment (less 

than 150 degrees Fahrenheit). It is not intended for use in attics or similar locations subject to 

temperatures in excess of that range.

Take care to ensure that neither you nor the pole comes near any power lines during installation.

The Outside Antenna must be installed no higher than 10 meters (32’9”) above ground.

Any antenna used with this device must be located at least 8 inches from all persons.

, you MUST REGISTER THIS DEVICE with your wireless provider 

and have your provider’s consent. Most wireless providers consent to the use of 

signal boosters. Some providers may not consent to the use of this device on their 

network. If you are unsure, contact your provider.

You MUST operate this device with approved antennas and cables as specified by 

the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any 

person.

You MUST cease operating this device immediately if requested by the FCC or a 

licensed wireless service provider.

 E911 location information may not be provided or may be inaccurate for 

calls served by using this device.

This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause 

harmful interference, and (2) this device must accept any interference received, including interference that may cause 

undesired operation. Changes or modifications not expressly approved by Wilson Electronics could void the authority 

to operate this equipment.