Wellink Corporation W202ER-4 Manual Do Utilizador
VisionNet 202ER-4 ADSL Ethernet Router User’s Guide.
115
Defining Bridge Interfaces
To enable bridging, you simply specify the device interfaces on
which you want to bridge data, and then enable bridging mode:
which you want to bridge data, and then enable bridging mode:
1. Launch Configuration Manager and click the Bridging in the
WAN tab.
The Bridge Configuration page displays, as shown in Figure 47.
Figure 47. Bridge Configuration Page
The table may be empty if bridging has not yet been
established.
established.
2. Select the interface names on which you want to perform
bridging and click
.
For example, select eth-0 (LAN) and eoa-0 (WAN) interfaces. If
you use such protocols on a USB-connected computer, you
can also select usb-0.
you use such protocols on a USB-connected computer, you
can also select usb-0.
Note
If you do not have an eoa-0 interface, but instead have an
interface named ppp-0 or ipoa-0, your device is not currently
configured with a WAN interface that allows bridging with your
ISP. You may want to check with your ISP to determine whether
they use the eoa protocol. See Chapter 14 for instructions on
creating an EOA interface.
interface named ppp-0 or ipoa-0, your device is not currently
configured with a WAN interface that allows bridging with your
ISP. You may want to check with your ISP to determine whether
they use the eoa protocol. See Chapter 14 for instructions on
creating an EOA interface.