Netgear 12200196 Manual Do Utilizador
Chapter 6. Advanced Settings
|
73
NETGEAR N300 Wireless Router with External Antennas WNR1500 User Manual
6.
Repeat
7.
Select the Turn Access Control On check box
When configuring the router from a wireless computer whose MAC address is not in the
Trusted PC list, if you select Turn Access Control On, you lose your wireless connection
when you click Apply. You must then access the router from a wired computer or from a
wireless computer that is on the access control list to make any further changes.
Trusted PC list, if you select Turn Access Control On, you lose your wireless connection
when you click Apply. You must then access the router from a wired computer or from a
wireless computer that is on the access control list to make any further changes.
8.
Click Apply to save your Wireless Card Access List settings.
Now, only devices on this list can wirelessly connect to the WNR1500 router.
Set Up Static Routes
Static routes provide additional routing information to your router. Under usual
circumstances, the router has adequate routing information after it has been configured for
Internet access, and you do not need to configure additional static routes. You must configure
static routes only for unusual cases such as multiple routers or multiple IP subnets located on
your network.
circumstances, the router has adequate routing information after it has been configured for
Internet access, and you do not need to configure additional static routes. You must configure
static routes only for unusual cases such as multiple routers or multiple IP subnets located on
your network.
As an example of when a static route is needed, consider the following case:
•
Your primary Internet access is through a cable modem to an ISP.
•
You have an ISDN router on your home network for connecting to the company where
you are employed. This router’s address on your LAN is 192.168.1.100.
•
Your company’s network address is 134.177.0.0.
When you first configured your router, two implicit static routes were created. A default route
was created with your ISP as the gateway, and a second static route was created to your
local network for all 192.168.1.x addresses. With this configuration, if you attempt to access a
device on the 134.177.0.0 network, your router forwards your request to the ISP. The ISP
forwards your request to the company where you are employed, and the request is likely to
be denied by the company’s firewall.
was created with your ISP as the gateway, and a second static route was created to your
local network for all 192.168.1.x addresses. With this configuration, if you attempt to access a
device on the 134.177.0.0 network, your router forwards your request to the ISP. The ISP
forwards your request to the company where you are employed, and the request is likely to
be denied by the company’s firewall.
In this case you must define a static route, telling your router that 134.177.0.0 should be
accessed through the ISDN router at 192.168.1.100.
accessed through the ISDN router at 192.168.1.100.
In this example:
•
The Destination IP Address and IP Subnet Mask fields specify that this static route
applies to all 134.177.x.x addresses.
•
The Gateway IP Address field specifies that all traffic for these addresses should be
forwarded to the ISDN router at 192.168.1.100.
•
A Metric value of 1 will work since the ISDN router is on the LAN.
•
Private is selected only as a precautionary security measure in case RIP is activated.