Netgear 17200386 Manual Do Utilizador

May 2017

350 East Plumeria Drive

San Jose, CA 95134, USA

Building 3, University Technology Centre  

Curraheen Road, Cork, Ireland 

Thank you for purchasing this NETGEAR product. You can visit  

 to register your product, get help, access the latest 

downloads and user manuals, and join our community. We recommend that you use 
only official NETGEAR support resources.

For the current EU Declaration of Conformity, visit

.

For regulatory compliance information, visit  

.

See the regulatory compliance document before connecting the power supply.

© NETGEAR, Inc., NETGEAR and the NETGEAR Logo are trademarks of NETGEAR, Inc. Any non-NETGEAR 

trademarks are used for reference purposes only.

•  Plastic bracket for either drop ceiling mounting or wall mounting. (

1)

•  Metal bracket for drop ceiling mounting. (

2)

•  One metal T-bar for drop ceiling mounting. (

3)

•  One lock screw to lock the T-bar for drop ceiling mounting. (

4)

•  Four short screws to attach the metal bracket for drop ceiling mounting. (

5)

•  Four tall screws to attach the plastic bracket for wall mounting. (

6)

•  Four anchors for the tall screws for wall mounting. (

7)

•  Four rubber feet for desk installation. (

8)

BETA DOCUMENT

If you are mounting the base station on a hard ceiling 
instead of a ceiling bar that is typical for a drop ceiling, 
use the wall installation instructions.

1.  Slide the T-bar partially into the metal bracket 

and attach the metal bracket to the ceiling bar. 
Then push the T-bar over the ceiling bar and use the 
lock screw to lock the metal bracket into place.

2.  Making sure that the two protruding 

hooks on the plastic bracket are facing 
down, place the plastic bracket against 
the metal bracket and align the four inner 
holes of the plastic bracket with the four 
holes of the metal bracket.
Then insert the four short screws and secure 
the plastic bracket onto the metal bracket.

3.  Hold the base station upside down, with 

the bottom facing the plastic bracket that 
is attached to the metal bracket, and align 
the two rectangular holes in the bottom of 
the access point with the protruding hooks 
on the plastic bracket.

4.  Push the hooks into the holes and turn the 

access point to secure it onto the plastic 

bracket.

1.  Place the plastic bracket on the wall where you want to mount the base 

station.

2.  Mark the wall where the four outer 

mounting holes are.

3.  Using the wall anchors and tall 

screws, attach the mounting bracket 

to the wall. 

4.  Align the two rectangular holes in 

the bottom of the access point with 
the protruding hooks on the plastic 
bracket.

5.  Push the hooks into the holes and turn the access point to secure it onto 

the plastic bracket.

For desk installation, attach the four round rubber feet to the locations marked by 
the gray circles on the bottom of the access point.

DRAFT