Xplore Technologies Corp. EM75 Manual Do Utilizador
12
• Do not use an apparently deformed or damaged battery pack, which may leak, overheat,
emit smoke, burst, and/or ignite.
• Do not directly solder the battery pack. Heat can melt the insulation and damage other
safety features, possibly causing it to leak, overheat, emit smoke, burst, and/or ignite.
• Store the battery pack in a location where children cannot reach it. Make sure children
do not remove the battery pack from the Tablet PC or charger.
• If the battery pack leaks, gives off a bad odor, generates heat, becomes discolored or
deformed, or in any way appears abnormal during use, recharging or storage,
immediately remove it from the Tablet PC or charger and stop using it. If this is
discovered when you first use the battery, return it to your Xplore reseller or to Xplore
Technologies, if you bought it directly from Xplore.
immediately remove it from the Tablet PC or charger and stop using it. If this is
discovered when you first use the battery, return it to your Xplore reseller or to Xplore
Technologies, if you bought it directly from Xplore.
• Do not transport the lithium ion batteries used in your Tablet PC in checked baggage.
You may take up to two spare batteries in carry-on baggage in addition to the one in
your Tablet PC. Transporting batteries in checked baggage or transporting more than
two spare batteries in carry-on baggage violates transportation law. Remember to
remove batteries from the battery charger before transporting it in carry-on or checked
baggage.
your Tablet PC. Transporting batteries in checked baggage or transporting more than
two spare batteries in carry-on baggage violates transportation law. Remember to
remove batteries from the battery charger before transporting it in carry-on or checked
baggage.
Regulatory and safety compliance
The following sections describe regulatory and safety compliance by country and by region.
Note: To determine which regulatory and safety marks apply to a specific product, component,
or accessory, check the product label affixed to the product and/or its components.
or accessory, check the product label affixed to the product and/or its components.
Federal Communications Commission notice (USA)
Electromagnetic Interference (EMI) is any electromagnetic disturbance that interrupts, obstructs,
or otherwise degrades or limits the effective performance of electronics or electrical equipment.
These emissions can potentially disrupt, degrade, or otherwise interfere with authorized
electronic emissions, which may include television, AM/FM broadcasts, cellular services, radar,
air-traffic control, and pagers.
or otherwise degrades or limits the effective performance of electronics or electrical equipment.
These emissions can potentially disrupt, degrade, or otherwise interfere with authorized
electronic emissions, which may include television, AM/FM broadcasts, cellular services, radar,
air-traffic control, and pagers.
The FCC Rules and Regulations have established Radio Frequency (RF) emission limits to
provide an interference-free RF spectrum. Many electronic devices, including computers,
generate RF energy incidental to their intended function and are, therefore, covered by these
rules.
provide an interference-free RF spectrum. Many electronic devices, including computers,
generate RF energy incidental to their intended function and are, therefore, covered by these
rules.
Unintentional Emitter per FCC Part 15
The rating label on Xplore Tablet PCs, docking stations, and all accessories show which class
(A or B) these devices fall into. Class B devices have an FCC logo (shown here) or FCC ID on
the label. Class A devices do not have an FCC ID on the label. Once you determine the class of
the device, refer to the following corresponding statement and to the FCC notices in this Safety
and Regulatory Guide.
(A or B) these devices fall into. Class B devices have an FCC logo (shown here) or FCC ID on
the label. Class A devices do not have an FCC ID on the label. Once you determine the class of
the device, refer to the following corresponding statement and to the FCC notices in this Safety
and Regulatory Guide.
• Class A is a digital device that is marketed for use in a commercial, industrial, or
business environment, exclusive of a device that is marketed for use by the general
public or is intended to be used in the home.
public or is intended to be used in the home.
• Class B is a digital device that is marketed for use in a residential environment
notwithstanding use in commercial, business, and industrial environments. Examples of